Manuales relacionados para Yardistry YM11515
Resumen de contenidos para Yardistry YM11515
- Página 1 Installation Manual -YM11515 4 High Lattice - X Privacy Panel Yardistry Ltd. Mount Forest, ON Canada N0G 2L1 Toll Free Customer Support: 1.888.509.4382 info@yardistrystructures.com www.yardistrystructures.com Revised 04/13/2011...
- Página 2 Tools Required Warranty: Yardistry Limited products are backed by a 5 year limited lifetime warranty from the date of original retail purchase for manufacturing defects and if installed as per manufacturer’s installation instructions. • Tape Measure •...
- Página 3 Material List (2) Top and Bottom Rail #8 x 2 1/4” Wood Screw #10 x 1” Pan Head Screw (4) One High X Topper #8 x 1 1/2” Wood Screw (6) Panel Clips (4) Three High Lattice Panel...
- Página 4 Step 1- Assemble Panels 1. R emove the upper metal connectors on both sides of PL3 - Three High Lattice Panel. Reattach the metal connectors to PL3 by securing the bottom two holes of the metal connectors to the top two holes on PL3 so that the metal connectors stick out from the top. Slide PX1 – One High X Topper between the two protruding metal connectors on the top of PL3. Attach the metal connectors to PX1. (Fig. 1A) *Ensure Panels are oriented correctly! (Fig. 1B) 2. S ecure panels with a S4 - 2 1/4” Wood Screw the location indicated by the large...
- Página 5 Step 2- Assemble Wall Fig. 1 1. Assemble panels together in configuration shown. (Fig.1) Insert male connector into female. Slide down until flush with adjacent Instruc Assemble Toppers to Panels. Instructions de base Pautas básicas para Cut and attach T Pautas básicas para pour l' panel as shown. (Fig. 1A) Basic Guidelines el ensamblado de Instale los topes en los paneles.
- Página 6 Step 3- Installing Panel Clips 1. Postition Panel Clips in locations indicated in Figures 1 and 1A. Ensure Panel Clips are oriented in the same direction facing outside the Pergola! 2. P anel Clips should be placed in the centre of the post or the leading edge of the clip should be 1 3/8” or 3.5cm away from the side of the post as shown in Fig. 2. 3. W ith Panel Clips in place, mark screw holes with a pencil and pre-drill holes with a 1/8” drill bit. (Not provided) 4. S ecure Panel Clips in locations indicated in figure 1 and 1A with S7- #8 x 1 1/2” wood screws. Fig.
- Página 7 Step 4- Installing Wall Into pergola 1. With the help of an adult, place the Wall on Panel Clips as shown (Fig.1) allowing a 4” gap between the bottom of the post and the bottom edge of the bottom rail on the panel assembly. 2. With a 1/8” drill bit, predrill holes as shown in figure 2. 3. F asten the Wall to the post and Panel Clips with a S5- 1” Pan Head Screw provided in location of arrows. (Fig. 1) Fig.