Publicidad
Step 1- Assemble Panels
1. R emove the upper metal connectors on both sides of PL3 - Three High Lattice Panel. Reattach the metal
connectors to PL3 by securing the bottom two holes of the metal connectors to the top two holes on PL3 so that
the metal connectors stick out from the top. Slide PX1 – One High X Topper between the two protruding metal
connectors on the top of PL3. Attach the metal connectors to PX1. (Fig. 1A) *Ensure Panels are oriented
correctly! (Fig. 1B)
2. S ecure panels with a S4 - 2 1/4" Wood
Screw the location indicated by the large
arrow in the direction of the arrow.
3. Repeat until four panel assemblies are
created.
été percés à
Fig. 1B - Filler Strips on Bottom
4x
One High X Topper
PX1
4x
Three High Lattice Panel
PL3
Pilot holes to the right
of Panel!
x4
PX1
Note orientation of keyhole.
Tenga en cuenta la orientación
del agujero de la cerradura.
Notez l'orientation de l'encoche
en trou deserrure.
4x
#8- 2 1/4" Wood Screws
S4
4
Fig. 1A
Do not remove Small Connector
PL3
No retire los conectores
Ne retirez pas les petites pièces d
raccordement.
Publicidad
