Infrared Interface, Send Measurement Data; Deleting Stored Measurement Data / Display Of All Memory Entries - BEHA Unitest TELARIS Fi/RCD Manual De Instrucciones

Infrared Interface, send Measurement Data

6.1 Infrared Interface, send Measurement Data
Additionally, all memorised measurement data may
be transferred to the PC (data archive) by means of
an Infrared Interface. For this purpose, the interfa-
ce adapter and the Software "Report-Studio" and In-
terface, available as an optional feature, are requi-
red.
The data transfer procedure is fairly easy:
Apply the Interface adapter to TELARIS
Connect adapter cable to PC (COM 2) via
9pole D-sub plug (RS232).
Call the "Report-Studio" Software (please
refer to user manual "Report-Studio").
Select menu item "read data" or select the
button "read data from measurement instru-
ment" by mouse click. The message "send
data" appears.
Press key "Send" (26).
Data transfer is carried out. After a few se-
conds all stored data is available for further
processing in the PC.
For further details, please refer to user manual
"Report-Studio".
46
7.0 Deleting Stored Measurement Data / Display
of All Memory Entries
It is possible to delete data by using key „Clear" (27).
Furthermore, it is possible to display the total num-
ber of measurement value entries on the display:
Display of Total Number of Measurement Value
Entries:
Set measurement range selection switch
(31) to one of the 5 measurements ranges.
Briefly press „Clear" key (27). A short beep
signal is audible.
The total number of all measurement values
that have been saved is now displayed.
Delete Last Stored Measurement Value:
Set measurement range selection switch
(31) to one of the 5 measurement ranges.
Briefly press „Clear" key (27). A short beep
signal is audible and the number of the mem-
orised measurement data is displayed.The
total number of all stored measurement data
is displayed.The display disappears after ap-
proximately 2 seconds.
Now release the key „Clear" (27) to avoid
deletion of all memory entries.
Deleting the last measurement value can be re-
peated as often as required, as long as data is
available within the memory.
Deleting all Stored Measurement Values:
Set measurement range selection switch
(31) to one of the 5 measurement ranges.
Press „Clear" key (27) for approx. 5 seconds.
A beep signals are audible. The number of all
stored measurement values is displayed.
The last stored value is deleted after 2 sec-
onds. After 5 seconds, all values are deleted.
„0" appears on the display. The memory is
completely deleted, the „M" symbol in the
display disappears.