Flash Exposure Correction (Ev); Manual Partial Light Output (P) - Metz MECABLITZ 58 AF-1 digital Manual De Instrucciones

Para cámaras digitales pentax- / samsung slr con p-ttl / ttl
Ocultar thumbs Ver también para MECABLITZ 58 AF-1 digital:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 182

6.3 Flash exposure correction (EV)

Manual flash exposure correction (EV) can help offset extreme differences in
contrast between the subject and background. Corrections from -3 f-stops (EV)
to +3 f-stops (EV) can be made, in 1/3 increments (also see 11.5).
Flash exposure correction is only activated in the TTL and P-TTL flash
modes if the camera supports this function (see the camera's operating
instructions)! Flash exposure correction is activated in automatic flash
mode A irrespective of the camera model!
Setting procedure:
A
F 8.0
• Press the
MZoom 70
11 m
EV 0
hes on the LC display.
Para
+
• Set the desired EV value using the
buttons.
The setting takes effect immediately.
A
F 8.0
MZoom 70
5,7 m
EV+2
• Press the button
+
Para
the normal view. If the button
display will change back to the normal view after
about 5 seconds.
Para
button (Parameters) until „EV" flas-
+
and
to change the LC display back to
is not pressed, the

6.4 Manual partial light output (P)

M
In the manual mode
adjusted to fit the shooting situation with the manual partial light output para-
meter (P). Settings in manual flash mode M range from P 1/1 (full light output)
to P 1/256, in intervals of 1/3.
Setting procedure:
• Press the
Para
button (Parameters) until „P" appe-
ars on the LC display.
• Set the desired light output (1/1-1/256) with the
+
and
buttons. The setting takes effect
immediately.
• Press the button
to change the LC display back to
the normal view. If the button
display will change back to the normal view after
about 5 seconds.
In strobe mode
adjusted to fit the flash parameters chosen.
In strobe mode
possible in full intervals.
When the number of flashes (N) and the flash frequency (f) are reset, the
partial light output is not reset.
and the strobe mode
, the light output can also be
M
M
is not pressed, the
, the maximum partial light output is automatically
, reduction of the manual partial light output is only
F 8.0
MZoom 35
11 m
P1/1
+
Para
F 8.0
MZoom 35
4,0 m
P1/8
Para
+
121

Publicidad

Tabla de contenido
loading

Tabla de contenido