Publicidad
Idiomas disponibles
Idiomas disponibles
Before
performing
cleaning,
changing, repairing and maintenance work, remove the
battery pack from the power tool.
Replace worn out or damaged parts immediately, so that
the power tool is always in a safe operating condition.
Cleaning:
Always keep the power tool clean and dry, free from oil,
lubricants or grease. The power tool must be thoroughly
cleaned after each use.
Do not use aggressive cleaning products. These products
may damage plastics and metals, compromising the safe
operation of the power tool.
Maintenance:
Only maintenance works described in this instruction
manual may be carried out all other works must be
performed by an official dealer.
Keep all nuts and bolts well tightened in order to ensure a
safe operation.
If any components or safety devices are removed for
maintenance
works,
immediately and correctly.
Use only VITO-approved tools for this machine or
technically identical parts. Failure to do so may result in
personal injuries or damages to the cordless angle grinder.
If in doubt, if you lack knowledge or resources, you should
contact an official dealer.
The cordless angle grinder should only be serviced by the
brand's technical assistance center, or other qualified
personnel, replacing any necessary parts with original
ones.
adjusting,
accessories
they
must
be
repositioned
The auxiliary handle (5) can be fitted in two different
positions to adapt the power tool to the work to be done
and make easier its handling.
1. Insert the auxiliary handle bolt into one of the threads on
the metal gear head (12);
2. Screw the auxiliary handle in clockwise until it is fully
tightened in place.
The position of the disc guard can be adjusted to suit the
working conditions. The disc guard must be fitted on the
appliance so that the closed side of the guard always points
toward the user.
1. Install the disc guard (4) with the protrusion on the guard
band aligned with the notch of the gear head (12);
2. Turn the disc guard according to the desired position;
3. Tighten the guard locking tab (1). Tighten the guard
locking tab;
4. To remove the disc guard, follow the installation
procedure in reverse.
1. Make sure that the disc guard (4) is fitted;
2. Insert the inner flange (2) onto the spindle. Ensure that
the flange is placed on the spindle;
3. Insert the disc (3) into the inner flange. Make sure the
disc is correctly installed;
4. Screw the outer flange onto the thread of the spindle;
5. Press the spindle lock button (11) and turn the disc by
hand until it locks. Keep the spindle lock button pressed
in and tighten the outer flange with the supplied
spanner;
6. Perform a test, at maximum speed, to check the correct
installation of the disc;
7. To remove the disc, follow the installation procedure in
reverse.
Wear protective gloves when installing accessories.
Publicidad
