Publicidad
Idiomas disponibles
Idiomas disponibles
Question/Problem - Cause
Cause
The angle grinder does not start when you press the
ON/OFF switch:
• The battery is discharged;
• ON/OFF contacts are not in good condition or it does
not work;
The "ON/OFF" switch is locked:
• The safety lever is not pressed;
The
motor
makes
intermittently or runs slowly:
• ON/OFF switch contacts are damaged;
• Mechanical parts are blocked/clogged;
• The angle grinder is running over excessive pressure,
overloaded motor;
The accessories vibrate excessively during operation:
• The outer flange is not tightened correctly;
Housing overheats:
• Overloaded equipment;
• Poor assembly of the housing or pieces inside the
angle grinder;
an
abnormal
sound,
Solution
• Charge it;
• Repair or replace the switch;
• Press the safety lever;
starts
• Repair or replace the switch;
• Inspect the mechanical parts;
• Reduce the pressure applied;
• Tighten;
• Reduce the pressure applied;
• Check if there is any blockage or part touching the
spindle;
Publicidad
