Publicidad
Idiomas disponibles
Idiomas disponibles
Noise and vibration data:
The measured values have been determined in
accordance with EN 60745. The A-rated noise
level of the tool is typically:
Sound pressure level:
Sound power level:
Uncertainty K:
Vibration values (vector total of three directions)
determined in accordance with EN 60745:
Screws:
Vibration emission value: a
Uncertainty:
NOTE
►
The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and
can be used for equipment comparisons. The
specified vibration emission value can also
be used to make an initial exposure estimate.
WARNING!
►
The vibration level varies depending on the
use of the power tool and may be higher
than the value specified in these instructions
in some cases.
Regular use of the power tool in this way may
cause the user to underestimate the vibra-
tion. To estimate the vibration load during
a specific working period accurately, also
take into account periods during which the
appliance is switched off (or running, but not
being used). This can significantly reduce the
vibration load over the total working period.
PSF 4.6 A1
L
=
67.2 dB (A)
pA
L
=
78.2 dB (A)
WA
K
=
3 dB
pA/WA
= 0.6 m/s
2
h
K = 1.5 m/s
2
General Power Tool
Safety Warnings
WARNING!
►
Read all safety warnings and all instruc-
tions. Failure to follow the warnings and
instructions may result in electric shock, fire
and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool.
1. Work area safety
a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
2. Electrical safety
a) Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets
will reduce risk of electric shock.
b) Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of elec-
tric shock if your body is earthed or grounded.
c) Do not expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electric shock.
d) Do not abuse the cord. Never use the cord
for carrying, pulling or unplugging the power
tool. Keep cord away from heat, oil, sharp
edges or moving parts. Damaged or entangled
cords increase the risk of electric shock.
GB │ IE
│
15
■
Publicidad
