Create Wind Flowood Manual De Instrucciones página 9

• To avoid personal injury and injury, ensure that the fan is hung in a location that allows
the blades to be 2.3 m or more from the floor and 76 cm from the nearest wall or obstacle.
• Make sure the mounting bracket is adequately secured to the building structure and can
support the full weight of the fan.
IN STALLIN G THE MOU NT I NG B R ACKE T
• Check that the ceiling where you intend to mount the fan is stable and capable of safely
supporting the weight of the fan.
• Do not fix the mounting bracket directly on ceilings less than 10mm to avoid the risk of the
screw loosening and coming out.
Wood roof
Drill the necessary holes and then secure
the mounting bracket with the wood screws
and washers to the ceiling joints.
concrete roof
NOTE: This fan can also be installed in a false ceiling, for this you must use fixing screws
with a spring lever (not included).
• Mark the correct position of the holes and fix the ceiling support using the screws with
metal anchors or screws and washers suitable for the type of ceiling chosen.
• Verify proper installation of the bracket before hanging the fan. The mounting bracket
must support the entire weight of the fan.
C H OICE OF MOU NTI NG T YP E
Traditional assembly
The traditional setup hangs from the ceiling
with a rod.
Drill holes with an 8mm drill bit, accord-
ing to the length of the expansion screws.
Next, secure the mounting bracket to the
ceiling with the expansion screws.
Angle mounting
Angle mounting is recommended on sloped
or vaulted ceilings.
E NGLI SH
9