(Gran Milano) - SWM SILVER VASE Manual Uso Y Mantenimiento

Ocultar thumbs Ver también para SILVER VASE:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

REASSEMBLING THE FRONT WHEEL

(GRAN MILANO)

Fit the L.H. spacer (D) on the wheel hub.
Fit the wheel between the fork legs.
1
Fit the previously greased wheel pin (2) from the
right-hand side until it is up against the left-hand
leg; it is advisable to turn the wheel while carrying
2
out this operation. Tighten the screw (3) on the fork
L.H. side but DO NOT lock it.
Now, pump for a while, pushing the handlebar
D
downwards until you are sure that the fork legs are
perfectly aligned. Lock: the screws (1) on the R.H. leg
(10,4 Nm - 1,06 Kgm - 7.67 ft/lb), the screw (3) on the
3
L.H. side (50 Nm - 5,09 Kgm - 36,87 ft/lb), the screws
(1) on the L.H. leg (10,4 Nm - 1,06 Kgm - 7.67 ft/lb).
1
Fit the brake calliper on the disc; assemble the cal-
liper on its mounting plate and tighten the two
screws (4) at 25,5 Nm - 2,6 Kgm - 18.8 ft/lb. Ensure
that the brake disc slides between the calliper pads
without any friction or hard spots.
Note*: After reassembly, pull the brake control le-
ver until the pads are against the brake disc.
4
EN - 49

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Gran milanoGran turismo

Tabla de contenido