Headlamp Bulbs Replacement - SWM SILVER VASE Manual Uso Y Mantenimiento

FUSES
Fuse malfunction could cause problems for the mo-
torcycle.
To access the fuse box (1), remove the left-hand side
panel.
Before operating on the fuses, set the ignition
switch to and remove the key in order to pre-
vent short-circuits.
• Do not use fuses with a different capacity
from the original one.
1) 10A fuse
(Lambda sensor, bypass valve, injector, temper-
ature sensor, TPS, pressure sensor, coil, control
unit) - Injection system fuse.
2) 10A fuse
Fuel pump.
3) 15A main fuse
Starter motor, starter contactor.
4) 15A fuse
Spare fuse.
5) 10A fuse
Spare fuse.
6) 10A fuse
Spare fuse.
EN - 60
2
3
4
5
1

HEADLAMP BULBS REPLACEMENT

Position light5W bulb.
High-beam/low-beam light: 60/55W bulb.
Proceed as follows to reach the headlamp bulbs:
- Undo the two side screws (1) that lock the head-
lamp ring nut (2) to the holder.
- Remove the ring nut (2) together with the head-
lamp and disconnect the wiring connector (3).
- slide off the rubber gaiter (4);
- detach connector (5) from the bulb;
- release the bulb holder clips (6) and take out bulb
(7).
Note*: Headlamp bulb (7) is of the halogen type; be
careful when replacing it since the glass part shall
not be touched with bare hands.
To replace the parking light bulb (8) extract it from
the inside cover.
When replacement is complete, refit everything op-
erating in reverse order from removal.
6
2
1