Hilti 2127969 Manual De Instrucciones Original página 15

Ø hammer drill bits
Ø hammer drill bits
Ø drill bits for wood
Ø drill bits for wood
Ø drill bits for metal
Ø drill bits for metal
5 Operation
5.1 Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or
before changing accessories.
Observe the safety instructions and warnings in this documentation and on
the product.
5.1.1 Fitting the side handle
1. Release the side handle clamping band by turning the handle grip.
2. Slide the side handle clamping band over the tool holder from the front
and into the recess provided.
3. Bring the side handle into the desired position.
4. Tighten the side handle clamping band by turning the handle grip.
5.1.2 Fitting the depth gauge (optional)
1. Release the side handle clamping band by turning the handle grip.
2. Slide the depth gauge from the front into the 2 guide holes provided.
3. Tighten the side handle clamping band by turning the handle grip.
▶ The depth gauge is fitted. To set the drilling depth:
4. Release the screw at the depth gauge.
5. Adjust the depth gauge to the desired drilling depth.
6. Tighten the screw at the depth gauge.
5.1.3 Fitting/removing the accessory tool
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or
have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
*2102963*
3
2102963
TE 50­AVR
1/2 in ...
1 1/4 in
12 mm ...
32 mm
1/4 in ...
1 3/8 in
6 mm ... 35 mm
1/4 in ... 1/2 in
6 mm ... 13 mm
4
5
English 9