DeWalt DXV06PL-QT Manual De Instrucciones página 7

WARNING:
The operation of any utility vac can result in
foreign objects being blown into the eyes,
which can result in severe eye injury. Always
wear safety goggles complying with ANSI
Z87.1 (or in Canada, CSA Z94.3) before
starting operation.
After you plug the power cord into the wall
receptacle, turn the unit "ON" by pushing the
switch from position "O" to position "I".
The "O" is the "OFF" position and the "I" is
the "ON" position.
ON
DRY PICK-UP
1. The lter must always be in correct position to
reduce the risk of leaks and possible damage
to vac. Make sure that the lter is completely
covering the lter cage. Make sure there are
no gaps between the lter and the lid. It is
very important to assemble the lter to the
cage without any possible leaks or tears.
2. When using the vac to pick up ne dust,
it will be necessary to empty the dust tank
and clean or replace the lter at more
frequent intervals to maintain peak vac
performance.
NOTICE:
A dry lter is necessary to pick up dry material. If
use the vac to pick up dust when the lter is
wet, the lter will clog quickly and be very dif cult
to clean. If the lter gets wet, replace it before
continuing to do dry pickups.
INSTALLING THE CARTRIDGE FILTER
The cartridge lter can be used for wet or dry
pick-up, installation is the same for both.
1. With the power head in an upside down position,
slide the cartridge lter down over the lid cage,
push the lter seals against the power head.
2. Turn the knob on lter retainer clockwise to
tighten, the lter into place.
OFF
5
3. To remove the lter for cleaning, turn the lter
knob counter clockwise till feel the tactile and
auditory cue, and make sure the knob arrow
align with the "Unlock" icon on the lter cap,
then slide the cartridge lter off the lid cage.
then grasp the step of knob tightly with ngers
to pull the cartridge lter out off the cage.
4. To clean the cartridge lter, shake or brush off
excess dirt or rinse (from the inside of the lter)
with water, dry completely (approximately 24
hours) and re-install.
NOTICE:
If the lter has been used for wet pick-up, it must
be cleaned and dried before dry pick-up.
INSTALLING THE DISPOSABLE FILTER
BAG
1. Slide the cardboard collar opening rmly onto
the vacuum port de ector until it stops against
the de ector wall.
2. Position the bag so that it is distributed around
the inside of the tank.
3. Replace and secure the power head onto the
tank.
Disposable
dust bag
ENGLISH
Lock