DeWalt DXV06PL-QT Manual De Instrucciones página 9

WARNING:
Do not remove lter cage and oat. The oat
prevents water from entering the impeller and
damaging the motor. The cage prevents ngers
from touching the moving impeller.
NOTICE:
To avoid damage to the impeller and motor,
always reinstall the Clean Connect™ lter before
using the vac for dry pickups and wet pickups.
NOTICE:
After cleaning, check the lter for tears or small
holes. Do not use a lter with holes or tears
in it. Even a small hole can cause a lot of
dust to come out of the vac.
Replace it immediately.
NOTICE:
Before installing the lter on the vac, clean the
area of the lid so that the lter will seal against
the lid and stop small particles from bypassing
the lter bag. If the lter is clean and not
damaged, replace it on the lter cage.
If it cannot be reused, place a new lter over
the lter cage.
NOTICE:
Clean the lter in an open area. Cleaning should
be done outdoors and not in living quarters.
CLEANING
To keep the wet/dry vac looking its best, clean
the outside with a cloth dampened with warm
water and mild soap.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with warm water and
mild soap.
3. Wipe with dry cloth.
STORAGE
Before storing the vac, the dust tank should be
emptied and cleaned. The cord should be
wrapped and hung on the unit and the
accessories should be kept in accessory bag
so they can be readily available. The vac should
be stored indoors.
TROUBLESHOOTING
Minor problems often can be xed without calling
customer service.
PROBLEM
Motor does not run
Suction capacity
decreases
Vacuum stops
running
Dust comes out
while vacuuming
7
ENGLISH
SOLUTION
Check power cord, plugs and outlet.
Ensure the on/off switch is in the
ON position (I).
Remove blockages in the nozzle,
extension wands, hose or lter.
Replace the paper or disposable
lter bag.
Check for proper installation of the
lter.
Clean or replace the lter.
Empty the dust tank, refer to
the tank Operating
under
instructions.
Thermal overload has been tripped:
1. Turn the vacuum off and
disconnect vacuum cleaner from
power source.
2. Empty the dust tank, if needed.
3. Allow the unit to cool.
4. Plug the power cord into an
appropriate outlet and turn on/off
switch to the ON position (I) to
test. If vacuum will not restart
call 1-888-899-0146.
Check for proper installation of the
lter.
Ensure lters are not damaged;
replace if necessary.
Ensure lter seals are in place and
are secure.
Empty