DeWalt DXV06PL-QT Manual De Instrucciones página 8

ENGLISH
WET PICK-UP
This cleaner requires minimal conversion when
going from dry to wet pick-up. A clean cartridge
lter may be used for vacuuming small amounts of
liquid. For best results when vacuuming large
amounts of liquid, remove the cartridge lter and
any disposable or reusable dust lters, Install the
foam lter. Installing the foam lter will help to
protect the motor and minimize the potential for
misting that may appear in the exhaust air or
dripping of liquid around the lid.
1. This wet/dry vac is equipped with a oat
mechanism which will rise automatically as liquid
enters the tank. When the liquid in the tank
reaches a predetermined level, the oat
mechanism will cut off the air ow. You will know
when the oat mechanism has cut off the air ow
because the suction ceases and the motor
makes a higher pitched noise due to increased
motor speed. The liquid capacity of the tank may
vary with the rate of liquid pick-up.
2. When this happens, turn off the vac. Refer to
"EMPTYING THE TANK" for removing liquid
from the tank.
3. After completing a wet pick-up job, raise the
vacuum hose to drain any remaining excess
liquid into the tank before emptying the tank
one nal time.
IMPORTANT: To reduce the risk of damage
to the vac, do not run motor with oat in
raised position.
Float in raised position
Foam filter
6
NOTE: IF ACCIDENTALLY TIPPED OVER,
THE VACUUM COULD LOSE SUCTION. IF
THIS OCCURS, PLACE VAC IN UPRIGHT
POSITION AND TURN SWITCH OFF. THIS
WILL ALLOW THE FLOAT TO RETURN TO
ITS NORMAL POSITION, AND YOU WILL BE
ABLE TO CONTINUE OPERATION.
EMPTY THE TANK
WARNING:
To reduce the risk of injury from accidental
starting, unplug power cord before emptying
the dust tank.
1. Remove the power head assembly of the
wet/dry vac by pulling outward on the lid
latch located on each side of the vac.
Lift off the power head assembly.
2. Dump the tank contents into the proper
waste disposal container.
CARE AND MAINTENANCE
FILTER REPLACEMENT
WARNING:
To reduce the risk of injury from accidental
starting, unplug power cord before changing or
cleaning the lter. The lter should be cleaned
often to maintain peak vac performance.