Publicidad
Idiomas disponibles
Idiomas disponibles
The water temperature must be kept below 104°F/ 40°C.
After washing the filter, allow it to dry.
To replace, put the filter back in its housing (fig. 10).
10
CHECKS AT THE BEGINNING OF THE SEASON
Make sure the power cable and socket are in perfect condition
and make sure the ground system is sufficient. Comply strictly
with the installation standards.
END OF SEASON OPERATIONS
To completely drain the water from the internal circuit, remove
the cap from the lower drainage hose, turning it counter clock-
wise, and pulling it to remove the internal cap (figure 11).
Drain the water completely into a basin (fig.12). When it is total-
ly drained, replace the caps, making sure they are closed. Clean
the filter as indicated previously. The filter must be dry before
reinserting it.
9
11
11
13
TECHNICAL SPECIFICATIONS
Power supply voltage
Max. absorbed power
during air conditioning
Refrigerant
Cooling capacity
LIMIT CONDITIONS
Room temperature for air conditioning
Transporting, loading, cleaning, recovery and disposal of
the refrigerant must only be performed by technical ser-
vice centers authorized by the manufacturing company.
The appliance must only be disposed by specialized per-
sonnel authorized by the municipality in which you live.
TO AVOID DAMAGE TO THE UNIT:
Attention!
NEVER TRANSPORT OR TURN THE APPLIANCE UPSIDE DOWN OR
ON ITS SIDE. IF THIS OCCURS, WAIT 6 HOURS BEFORE TURNING
THE APPLIANCE ON, 24 HOURS IS RECOMMENDED. After the unit
has been on its side, oil needs to return to the compressor to en-
sure proper function. Without allowing the unit this time (6-24
hours) the unit may function for only a short time, and then the
compressor will break down from lack of oil.
12
see rating label on the product
"
"
"
64° - 95°F
(18° - 35°C)
Publicidad
