Publicidad
Idiomas disponibles
Idiomas disponibles
Maximum torque
Maximum drilling capacity in wood
Maximum drilling capacity in metal
Weight (According to EPTA procedure
01/2003)
Weight - not incl. battery pack
Ambient
operating
and
temperature for the tool and battery pack
(Limited performance at temperatures
<0°C)
Recommended ambient charging
temperature
Recommended battery type
Recommended charger
Know Your Product
See page 3.
1. Keyless chuck
2. Torque adjustment ring
3. Gear selector
4. Direction of rotation selector
5. Trigger switch
6. Handle, insulated gripping surface
7. LED light
8. Battery pack
9. Belt clip
Intended Use
The drill driver can be used for drilling into various materials, including
wood, metal, and plastics using a drill bit having a shank diameter of
less than 13 mm. The product can be used to drive and remove screws
and bolts using an appropriate bit.
For damage caused by usage other than intended, the user is
responsible.
Symbols
Read all safety warnings and all instructions.
Warning
V
Volts
Direct current
No-load speed
60 Nm
40 mm
13 mm
1.9 kg
1.2 kg
storage
-15 - 40°C
5 - 40°C
LI 18/2Ah BASIC
LI 18V/4Ah BASIC
LI 18V/5Ah BASIC
ALG 18/4 BASIC
ALG 18/6 FAST
CE conformity
British Conformity Mark
Regulatory Compliance Mark (RCM). Product
meets applicable regulatory requirements.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authority or retailer for recycling advice.
Battery
A battery that is new or has not been used for a longer period does
not develop its full capacity until after approx. 2 – 3 charging/
discharging cycles.
Do not place down the battery on radiators or expose it to intense
sunlight for longer periods; temperatures above 50 °C cause damage.
Keep the contacts/terminals of the charger and replaceable battery
clean. For optimal service life, fully charge the battery after use.
Battery Charging
NOTE: The battery supplied is partially charged. To ensure full
capacity of the battery, completely charge the battery in the battery
charger before fi rst-time use.
The lithium-ion battery can be charged at any time without reducing
its service life. Interrupting the charging process does not damage the
battery.
The lithium-ion battery is protected against deep discharging. When
the battery has no charge, the product is switched off by means of a
protective circuit. The inserted tool stops.
□ Stop pressing the trigger switch after the product has been
automatically switched off . The battery can be damaged.
Removing the Battery
To remove the battery, press and hold the unlocking button and pull
out the battery toward the front. Do not exert any force.
Observe the notes for disposal.
Dust Extraction
Dusts from materials such as lead-containing coatings, some wood
types, minerals and metal can be harmful to one's health. Touching
or breathing-in the dusts can cause allergic reactions and/or lead to
respiratory infections of the user or bystanders.
Certain dusts, such as oak or beech dust, are considered carcinogenic,
especially in connection with wood-treatment additives (chromate,
wood preservative). Materials containing asbestos may only be
worked on by specialists.
□ Provide for good ventilation of the working place.
□ It is recommended to wear a P2 fi lter-class respirator.
Observe the relevant regulations in your country for the materials
being worked on.
Maintenance and Cleaning
□ Disconnect the plug from the power source and/or the battery
pack from the power tool before making any adjustments,
15
Publicidad
