Publicidad
Idiomas disponibles
Idiomas disponibles
DRAIN Step 1
DRAIN INSTALLATION INSTRUCTIONS:
Slide the drain nuts and poly-vinyl washers onto the overflow and drain tubes.
Assemble the overflow and drain tubes loosely to the drain tee.
Note: The beveled edge of the washer and threaded side of the nut must
face the drain tee prior to assembly.
Dry mount the Overflow Assembly and Drain Shoe onto tub as shown.
Note: DO NOT detach Drain Shoe Cable for any reason. Cut Overflow
Assembly Tube and Drain Shoe Tube ends as necessary to achieve fit.
Remove rough edges with sandpaper prior to assembly.
DRAIN Step 2
Install Drain Shoe (D) using supplied brass Drain Bolt (A), Strainer (B)
and Gasket (C) as illustrated. Tighten Drain Bolt (A) to secure.
Do not overtighten or Drain Shoe assembly may be damaged.
Note: The top tub lip MUST be level. Verify top and bottom tub
floor sealing surfaces are clean, flat and smooth prior to assembly.
B
STRAINER
SILICONE CAULK
REQUIRED
D
DRAIN SHOE
DRAIN Step 4
Verify Poly-Vinyl Washers (I) are installed under Drain Nuts
(beveled side inward). Tighten Drain Nuts to secure Drain Tee.
Finally, tighten Brass Overflow Nut (J) with an adjustable wrench
to secure Overflow. Do Not Overtighten!
BRASS OVERFLOW NUT
J
I
OVERFLOW
ASSEMBLY
DRAIN
NUTS
DRAIN TEE
BRASS DRAIN BOLT
VERIFY STRAINER
IS LEVEL & FLUSH
WITH TUB SURFACE
TUB FLOOR
GASKET
C
VERIFY POLY-VINYL
WASHERS ARE INSTALLED
UNDER DRAIN NUTS
TUB FLOOR
DRAIN SHOE
DRAIN Step 3
Install Overflow Assembly (H) using supplied Round Gasket (E),
Flange Ring (F) and Brass Overflow Nut (G).
Finger tighten Brass Overflow Nut (G).
Note: Brass Overflow Nut (G) to be tightened further upon
completion of Step 4.
A
OVERFLOW
H
ASSEMBLY
DRAIN Step 5
Install Drain Knob over Overflow Shaft (set screw against
flat surface). Then adjust Knob for a 1/16"-1/8" wall gap as
illustrated. Finally, tighten set screw to secure.
!
CAUTION: Drain Knob wall gap is mandatory to allow
water to escape, preventing overflows.
MANDATORY DRAIN KNOB WALL GAP
1/16"-1/8"
2
OVERFLOW & DRAIN SHOE TUBE
MUST EXTEND 1"-1.5"
OVERFLOW
INTO DRAIN TEE ENDS
ASSEMBLY
DRAIN TEE
DRAIN SHOE
ROUND FLANGE RING
BRASS OVERFLOW NUT
ROUND GASKET
E
TUB WALL
3/32" ALLEN WRENCH
TUB WALL
F
G
754782-100 Rev. 8 7/19
Publicidad
