Publicidad
Idiomas disponibles
Idiomas disponibles
Use only spare parts and accessories
supplied and recommended by the
manufacturer .
Regularly check and maintain the product .
Have the product repaired in a licensed
workshop only .
When not in use, store the product out of
the reach of children .
Make sure that the air vents are free of dirt .
Vibration and noise reduction
To reduce the impact of noise and vibration
emission, limit the time of operation, use low-
vibration and low-noise operating modes as
well as wear personal protective equipment .
Take the following points into account to
minimise the vibration and noise exposure risks:
Only use the product as intended by its
design and these instructions .
Ensure that the product is in good condition
and well maintained .
Use correct accessory tools for the product
and ensure they are in good condition .
Keep tight grip on the handles/grip surface .
Maintain this product in accordance with
these instructions and keep it well lubricated
(where appropriate) .
Plan your work schedule to spread any high
vibration tool use across a longer period
of time .
Behaviour in emergency situations
Familiarise yourself with the use of this product
by means of this instruction manual . Memorise
the safety warnings and follow them to the
letter . This will help to prevent risks and hazards .
Always be alert when using this product,
so that you can recognise and handle risks
early . Fast intervention can prevent serious
injury and damage to property .
Switch the product off and disconnect it
from the mains if there are malfunctions .
Have the product checked by a qualified
professional and repaired, if necessary,
before you operate it again .
32 GB/IE
Residual risks
Even if properly operating and handling
the product, some residual risks will remain .
Due to its construction and build, the
product may present the following hazards:
–
Cuts;
–
Hearing loss if working without hearing
protection;
–
Damage caused to your health resulting
from hand/arm vibrations if the power
tool is used over a longer period of
time or if it is not properly used and
maintained .
NOTE
u
This product produces an electromagnetic
field during operation! This field may
under some circumstances interfere with
active or passive medical implants! To
reduce the risk of serious or fatal injury,
we recommend persons with medical
implants to consult their doctor and the
medical implant manufacturer before
operating this product!
˜ Before first use
˜ Unpacking the product
1 . Take the product out of the packaging and
remove all packaging materials and plastic
wrappings .
2 . Check to make sure that all listed parts are
included (see "Scope of delivery") .
3 . Check whether the product and all parts
are in good condition, if any damage or
defect is detected, do not use the product,
but follow the procedure described in
chapter "Warranty" .
˜ Assembly
Protective cover (Fig. B)
1 . Place the protective cover
12 ]
[
motor head
.
2 . Fasten the protective cover
2 cross-head screws
9 ]
[
onto the
9 ]
[
with
16 ]
[
.
Publicidad
