Publicidad
Idiomas disponibles
Idiomas disponibles
Spacer bracket
1 . Pull the spacer bracket
2 . Insert both open ends of the spacer
[
11 ]
bracket
into the lateral slots on the lower
12 ]
[
motor head
.
3 . The spacer bracket
2 positions .
Auxiliary handle (Fig. C)
1 . Unscrew and remove the pre-installed
14 ]
[
nut
and handwheel bolt
15 ]
[
auxiliary handle
2 . Pull the ends of the auxiliary handle
apart and slide them over the handle
17 ]
[
unit
.
3 . Screw on the auxiliary handle
[
18 ]
handwheel bolt
˜ Operation
m
CAUTION! Risk of injury!
u
Do not operate the product without the
9 ]
[
protective cover
u
Wear suitable clothing as well as eye
and ear protection .
u
Prior to every use, check that the product
is fully functional .
u
Do not lock the on/off switch
place . After releasing the on/off switch,
the motor must switch off . Stop using the
product if the on/off switch is damaged .
NOTE
u
Observe local regulations concerning
noise protection .
˜ Switching on/off
m
CAUTION! Risk of injury and
property damage!
u
Maintain a firm stand and hold the
product well with both hands at a safe
distance away from your body .
u
Before switching on the product, check
that it does not touch any objects .
[
11 ]
apart .
11 ]
[
snaps into
[
18 ]
of the
.
15 ]
[
15 ]
[
with the
[
14 ]
and nut
.
.
2 ]
[
in
m
CAUTION! Risk of injury and
property damage!
u
After the product has been switched off,
[
20 ]
the line spool
some time . Allow the line spool to come
to a complete stop .
u
Keep hands and feet at a safe distance
from the line spool
NOTE
u
For transport safety during delivery, the
cutting line is knotted at the ends . The
dual line auto-feed system regulates the
cutting width during initial start-up and
the knotted ends are automatically cut off
by the line cutter
u
The product cannot be switched to
continuous operation .
u
Remove grass cuttings regularly from the
20 ]
[
line spool
to make sure that cutting is
not impaired .
(Fig. E)
1 . Form a loop from the end of the extension
cord . Pass the loop through the opening on
1 ]
[
the upper handle
[
4 ]
strain relief
.
2 . Connect the product to the mains supply .
3 . Ensure your stance is stable and hold the
product tightly with both hands . Do not
allow the spool cap
4 . Switching on: Press and hold the on/off
2 ]
[
switch
.
5 . Switching off: Release the on/off
[
2 ]
switch
.
˜ Settings
(Fig. F)
Adjusting the auxiliary handle
You can adjust the auxiliary handle
various positions . Adjust the auxiliary handle so
10 ]
[
that the spool cap
as you work .
continues moving for
20 ]
[
.
21 ]
[
.
and hook it into the
10 ]
[
to hit the floor .
15 ]
[
to
is tilted slightly forward
GB/IE
33
Publicidad
