Parkside PRT 550 B6 Manual De Instrucciones página 35

˜ Cutting grass
H
o Cut the grass by swaying the product
sideways to the right and left .
Cut slowly and hold the product with the
o
cutting circle parallel to the ground when
cutting .
Cut tall grass by a series of levels from top
o
to bottom .
˜ Troubleshooting
Problem Possible cause
The product does
The on/off switch
not start .
The motor is defective .
The product works Internal loose contact .
with intermittent
The on/off switch
operation .
The product makes The trimming assembly is dirty .
much vibration and
loud noise .
The motor is defective .
The trimming result
The line spool
is bad .
enough cutting line .
Both or one of the cutting lines are/
is not protruding out of the line
spool
[ 2 ]
is defective .
2 ] [
is defective .
20 ] [
does not have
20 ] [
.
Settings for lawn trimming
[ 13 ]
o Handle section
Cutting angle: 90° (Fig . F )
o
11 ] [
o Spacer bracket
position/folded out (Fig . F )
˜ Lawn edge trimming
(Fig. G)
m
CAUTION! Risk of injury!
u
When working, hold the product so that
the protective cover
the trimming assembly .
Setup for edge trimming
To trim lawn edges, slowly move the product
along the lawn edges .
[ 13 ]
o Handle section
Cutting angle: 90° (Fig . F )
o
[ 11 ]
Spacer bracket
o
Action
Contact our customer service to have
the product repaired .
Clean the trimming assembly
(see "Cleaning") .
Contact our customer service to have
the product repaired .
Extend the cutting line if required
(see "Extending the cutting line") .
Replace the line spool
(see "Replacing the line spool") .
1 . Remove the line spool
2 . Feed the cutting line through
the line outlet loops
outside .
3 . Reinstall the line spool
: 0° (Fig . F )
as required: in resting
9 ] [
protects you from
: 90° (Fig . F )
in parking position
20 ] [
20 ] [
.
22 ] [
to the
[ 20 ]
.
GB/IE 35