Publicidad
Idiomas disponibles
Idiomas disponibles
[
14 ]
Loosen the nut
[
15 ]
handle
to the desired position . Re-
tighten the nut .
Adjusting the height
7 ]
[
The telescopic tube
product to your individual height .
Loosen the threaded bush
towards . Adjust the telescopic tube
to the correct length . Tighten the threaded
bush by rotating towards .
Adjusting the cutting angle
Changing the cutting angle allows you to trim
grass at places that are difficult to reach, e .g .
under benches or wall offsets .
Press the push button
housing and tilt the telescopic tube
There are 6 possible settings .
Adjusting the handle section
13 ]
[
The handle section
[
5 ]
Slide the latch
13 ]
[
handle section
desired position .
Adjusting the spacer bracket (flower
protection)
[
11 ]
The spacer bracket
assembly away from plants and trunks not to
be cut .
Push the spacer bracket
the spacer bracket is not in use, you can
move it back to its parking position .
Extending the cutting line
NOTE
u
Check the cutting line regularly for
damage . Make sure the cutting line has
the length specified by the line cutter
The product is equipped with a dual line
o
auto-feed mechanism .
34 GB/IE
and adjust the auxiliary
allows you to adjust the
6 ]
[
by rotating
[
7 ]
8 ]
[
on the motor
[
7 ]
.
can be rotated by 90° .
upwards and rotate the
until it latches into the
keeps the trimming
[
11 ]
forward . When
21 ]
[
The lines extend automatically every time
o
the product is switched on . For proper
functioning of the automatic line extension
mechanism, the line spool
stopped completely before you restart the
product .
If the lines are initially longer than the
o
cutting diameter, they are automatically
shortened to the right length by the line
[
21 ]
cutter
(Fig . D) .
If no line ends are visible: Replace
o
the line spool
spool") .
Setting the line length manually:
o
Disconnect the product from the mains
–
supply .
Press the lock button
–
pull the line ends out a little bit . Repeat
this process until the line ends protrude
slightly beyond the line cutter
˜ Working instructions
m
WARNING! Risk of injury!
u
Do not cut moist or wet grass .
u
Before switching on the product, make
sure that the line spool
touch any stones, scree, or other foreign
objects .
u
Switch on the product before you
approach the grass that is to be cut .
u
Do not overload the product during
operation .
u
Avoid contact with obstacles (stones,
walls, fences, etc .) . Otherwise the line
20 ]
[
spool
wears out quickly .
u
Avoid using the product in bad weather,
especially if there is a danger of
lightning .
u
Do not select a position for the auxiliary
.
15 ]
[
handle
1 ]
[
handle
. Otherwise you cannot control
the product properly .
20 ]
[
must have
20 ]
[
(see "Replacing the line
24 ]
[
, release it and
21 ]
[
20 ]
[
does not
that is too close to the upper
.
Publicidad
