Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting other machine settings
By tapping the Settings
- Water hardness: you can select between 5 levels according to the water hardness in your region;
- Standby time: you can select 15, 30, 60 or 180 min
- Display brightness: you can select low, medium and high.
- Language
- Sound: you can activate or deactivate the beeping sound of the machine
- Temperature: you can choose between 3 brewing temperatures for your coffee
- Front illumination (5500 series only): you can choose 'always on', 'on during brewing' or 'always
off'.
- Measuring unit: you can choose between ml. or oz.
- Profile activation: you can activate or deactivate profiles.
- Rinsing on start-up: you can activate or deactivate an automatic rinsing cycle when you switch
on the machine.
- Display backlight: you can activate or deactivate the backlight in the drink buttons.
Restoring factory settings
The machine offers you the possibility to restore the factory settings at any moment.
1 Tap the Settings
2 Use the up and down icons to select 'Factory settings'. Confirm by tapping the OK icon.
3 Press the start/stop
- The settings are now being restored.
The following factory settings are restored to default: water hardness, standby time, brightness,
display backlight, start-up rinsing, sound, temperature, front illumination, profiles.
Removing and inserting the brew group
Go to www.philips.com/coffee-care for detailed video instructions on how to remove, insert and
clean the brew group.
Removing the brew group from the machine
1 Switch off the machine.
2 Remove the water tank and open the service door (Fig. 21).
3 Press the PUSH handle (Fig. 22) and pull at the grip of the brew group to remove it from the
machine (Fig. 23).
Reinserting the brew group
Before you slide the brew group back into the machine, make sure it is in the correct position.
1 Check if the brew group is in the correct position. The arrow on the yellow cylinder on the side of
the brew group has to be aligned with the black arrow and N (Fig. 24).
- If they are not aligned, push down the lever until it is in contact with the base of the brew
group (Fig. 25).
icon you can adjust the following machine settings:
icon.
button to confirm you want to restore the settings.
English
11
Publicidad
