Publicidad
Idiomas disponibles
Idiomas disponibles
English
14
4 Tap the OK icon to confirm and then follow the instructions on the screen to remove any milk
that may be left inside the milk system.
- Small jets of hot water will be dispensed by the milk system.
5 Store LatteGo with the remaining milk in the fridge.
Thoroughly cleaning LatteGo
1 Remove LatteGo from the machine (Fig. 35).
2 Pour out any remaining milk.
3 Press the release button and remove the milk container from the frame of LatteGo (Fig. 36).
4 Clean all parts in the dishwasher or under the tap with lukewarm water and some washing-up
liquid.
AquaClean water filter
Your machine is AquaClean enabled. You can place the AquaClean water filter in the water tank to
preserve the taste of your coffee. It also diminishes the need for descaling by reducing limescale
build-up in your machine. You can purchase an AquaClean water filter from your local retailer, from
authorized service centers or online at www.philips.com/parts-and-accessories.
AquaClean filter status indication
When the AquaClean is active, the status of the AquaClean filter is always visible on the screen as a
percentage.
- If the status of the AquaClean filter is 10% or less, the screen shows a message for 2 seconds
each time you switch on the machine. This message advises you to buy a new filter.
- If the status of the filter is 0%, the machine asks you to replace the AquaClean filter every time
you switch on the machine.
Activating the AquaClean water filter (5 min.)
The machine does not automatically detect that a filter has been placed in the water tank.
Therefore you need to activate each new AquaClean water filter that you install in the 'Clean'
menu.
When the machine stops showing the filter activation message, you can still activate an AquaClean
water filter, but you will need to descale the machine first.
Your machine has to be completely limescale-free before you start using the AquaClean water
filter.
Before activating the AquaClean water filter, it has to be prepared by soaking it in water as
described below. If you don't do this, air might be drawn into the machine instead of water, which
makes a lot of noise and prevents the machine from being able to brew coffee.
1 Tap the 'Clean'
2 Tap the OK icon to confirm.
3 Tap the OK icon again when the activation screen appears. Follow the instructions on the screen.
4 Shake the filter for about 5 seconds (Fig. 37).
5 Immerse the filter upside down in a jug with cold water and shake/press it (Fig. 38).
icon and use the up and down arrows to select 'AquaClean'.
Publicidad
