Teka TNL 6401 Manual Del Usuario página 21

Fire risk exists in case that cleaning does not
take place according to the instructions.
Filter cleaning
To withdraw the filters from their locations
release the anchoring points. Clean the filter,
either by putting it in the dishwasher (see
notes) or leaving it standing in hot water to
simplify the removal of grease or, if wished, by
means of special sprays (protecting the non
metallic parts). Once clean, leave it to dry.
Notes: cleaning in the dishwasher with
aggressive detergents
surface of metallic parts, without this affecting
its gas retaining properties.
N.B. The filter must be cleaned at least once a
month depending on how often the extractor
is used. It must be remembered that grease is
deposited in the extractor when cooking,
whether it is switched on or not.
Cleaning of the extractor body
The use of warm (40ºC approx.) soapy water
is recommended. A cloth moistened in this
water is used for cleaning the extractor, paying
special attention to the grids. Afterwards, dry it
using a lint-free cloth.
Note:
• Never use metallic scouring pads or
abrasive products that could damage the
surface.
Electrical characteristics:
REFER TO RATING PLATE
This appliance has been designed, tested and
manufactured according to:
• Safety: EN/IEC 60335-1; EN/IEC 60335-
2-31, EN/IEC 62233.
To fix the extractor to the kitchen unit the
pattern on fig.3- 4 is used.
may blacken the
• Do not use scrapers with metallic surfaces
such as knives, scissors etc.
Activated charcoal filter
• To install the charcoal filter, disassemble
the lid, introduce the filter in the position
provided and reassemble the lid.
• The carbon filter lasts from three to six
months depending on the particular
conditions of use.
• The activated carbon filter can neither be
washed nor regenerated. Once it is
exhausted, it must be changed.
• To replace the exhausted filter with a new
one, we will make in the same way that in
its assembly, previously extracting the
spent filter.
• A reduction in the extraction flow rate may
be observed in the hood with the
installation of carbon filters.
Changing Bulbs
• Remove the filter support to acces the
bulbs.
• Take care to disconnect the mains
beforehand and that the bulbs to be
replaced are not hot.
• The maximum bulbs power is 40W.
• ILCOS D cod: DR-6-H-E14-37 or ILCOS
D cod: HSGSB/C-28-230-E14
• Performance: EN/IEC 61591; ISO 5167-1;
ISO 5167-3; ISO 5168; EN/IEC 60704-1;
EN/IEC 60704-2-13; EN/IEC 60704-3;
ISO 3741; EN 50564/IEC 62301.
• EMC: EN 55014-1 / CISPR 14-1; EN
55014-2 / CISPR 14-2; EN/IEC 61000-3-
2; EN/IEC 61000-3-3.
The lower part of the extractor must be
located at a minimum height of 50 cm above
the hob for electric cookers and 65 cm for gas
cookers. If the instructions of a gas cooker
EN
21