Publicidad
Idiomas disponibles
Idiomas disponibles
If the cooker hood is installed for use above a
gas appliance then the provision vor ventilation
must be in accordance with the Gas Safety
(Installation & Use) Regulations 1984 and the
relevant
Building
Saving Energy
This appliance is energy-efficient but there
are some tips on how to save even more
energy:
• During cooking, ensure that there is a
sufficient supply of air to enable the
extractor hood to work efficiently and with
a low level of operating noise.
• Adjust the fan speed to the amount of of
steam produced during cooking. Only use
intensive mode when required. The lower
the fan speed, the less energy is
consumed.
• If cooking produces large amounts of
steam, select the higher fan speed in
good time. If the cooking steam has
already spread around the kitchen, the
extractor hood will need to be operated
for longer thus consuming more energy.
• Switch off the extractor hood if you no
longer require it.
• Switch off the lighting if you no longer
require it.
• Clean and (if required) replace the filter at
regular
intervals
effectiveness of the ventilation system and
to prevent the risk of fire.
• Put the lid on pans to reduce cooking
steam and condensation.
Disposal of the packaging
The packaging bears the Green Point mark.
Dispose of all the packaging materials such
as cardboard, expanded polystyrene and
plastic wrapping in the appropriate bins. In
Regulations.
Detailed
to
increase
the
recommendations
following British Standard Codes of Practice
BS6172,
BS5440
Edition.
this way you can be sure that the packaging
materials will be re-used.
Dismantling the equipment:
1. Disconnect the mains power.
2. Remove the duct cover above the hood.
3. Disconnect the duct.
4. Supporting the equipment, remove the
srews that fix it to the wall.
5. For waste disposal, proceed according
to
the
appropriate
protection guidelines.
Disposal of equipment no longer used
According
to
2012/19/EU on the management of waste
electrical and electronic equipment (WEEE),
home electrical appliances should not be put
into the normal systems for disposal of solid
urban waste.
Outdated appliances should be collected
separately to optimize component material
recovery and re-cycling rates and to prevent
potential harm to human health and the
environment. The symbol of a rubbish
container superimposed by a diagonal cross
should be put on all such products to remind
people of their obligation to have such items
collected separately.
Consumers
should
authorities or point of sale and request
information on the appropriate places to
leave their old home electrical appliances.
Before disposing of your appliance, render it
non-usable by pulling out the power cable,
cutting this and disposing of it.
are
contained
in
and
BS6891
Current
environmental
European
Directive
contact
their
local
EN
the
23
Publicidad
