Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
WARNING:
the safety chapter before you use the
product.
Fuel
To use fuel
CAUTION:
stroke engine. Use a mixture of gasoline
and two-stroke engine oil. Make sure
to use the correct quantity of oil in the
mixture. Incorrect ratio of gasoline and
oil can cause damage to the engine.
Gasoline
CAUTION:
an octane number less than 90 RON
(87 AKI). This can cause damage to the
product.
CAUTION:
more than 10% ethanol concentration
(E10). This can cause damage to the
product.
CAUTION:
gasoline. This can cause damage to the
product.
•
Always use new unleaded gasoline with a
minimum octane number of 90 RON (87 AKI)
and with less than 10% ethanol concentration
(E10).
•
Use gasoline with a higher octane number if you
frequently use the product at continuously high
engine speed.
•
Always use a good quality unleaded gasoline/oil
mixture.
Two-stroke oil
•
For best results and performance use RedMax
two-stroke oil, which is specially formulated for
our two-stroke engines.
•
If RedMax two-stroke oil is not available, use
a different two-stroke oil of good quality that is
formulated for air-cooled engines. Consult your
servicing dealer when you select an oil.
•
Do not use two-stroke oil for water-cooled
outboard engines, also referred to as outboard
oil.
•
Do not use oil intended for four-stroke engines.
12
Operation
Read and understand
This product has a two-
Do not use gasoline with
Do not use gasoline with
Do not use leaded
Gasoline, l
5
10
15
20
US gallon
1
2 ½
5
To make the fuel mixture
Note:
Always use a clean fuel container when you
mix the fuel.
Note:
Do not make more than 30 days quantity of
fuel mixture.
1. Add half of the gasoline quantity.
2. Add the full quantity of oil.
3. Shake the fuel mixture to mix the contents.
4. Add the remaining gasoline quantity.
5. Shake the fuel mixture to mix the contents.
6. Fill the fuel tank.
To add fuel
•
Always use a fuel container with an antispill
valve.
•
If there is some fuel on the container, remove the
unwanted fuel and let the container dry.
•
Make sure that the area near the fuel tank cap is
clean.
•
Shake the fuel container before you add the fuel
mixture to the fuel tank.
To add fuel to the fuel tank
1. Stop the product.
2. Put the product on a flat surface.
3. Loosen the fuel tank cap to release the pressure
in the fuel tank.
4. Remove the fuel tank cap.
5. Fill the fuel tank to 80%.
6. Tighten the fuel tank cap fully.
7. Make sure that there is no leak in the fuel tank.
Two-stroke
oil, l
2% (50:1)
0.10
0.20
0.30
0.40
US fl. oz.
2 ½
6 ½
12 ⅞
2318 - 003 - 02.04.2024
Publicidad
