Publicidad
Idiomas disponibles
Idiomas disponibles
To install batteries:
1. Lift up the battery compartment cover
2. Insert three fresh AA batteries in the compartment, placing the batteries according to Fig. A
(+) and (–) on the inside of the battery door.
WARNING: Batteries can explode, or leak, and can cause injury or fire. To
reduce this risk:
•
Carefully follow all instructions and warnings on the battery label and package.
•
Always insert batteries correctly with regard to polarity (+ and –), marked on
the battery and the equipment.
•
Do not short battery terminals.
•
Do not charge batteries.
•
Do not mix old and new batteries. Replace all of them at the same time with
new batteries of the same brand and type.
•
Remove dead batteries immediately and dispose of per local codes.
•
Do not dispose of batteries in fire.
•
Keep batteries out of reach of children.
•
Remove batteries if the device will not be used for several months.
PERSONAL SAFETY
Stay alert, watch what you are doing and use common sense when operating a laser tool. Do not use tool while tired
•
or under the influence of drugs, alcohol, or medication. A moment of inattention while operating power tools may result in
serious personal injury.
•
Do not overreach. Keep proper footing and balance at all times. Proper footing and balance enables better control of the tool in
unexpected situations.
Use safety equipment. Always wear eye protection. Dust mask, non-skid safety shoes, hard hat, or hearing protection may be
•
required for appropriate conditions.
TOOL USE AND CARE
Do not use tool if switch does not turn it on or off. Any tool that cannot be controlled with the switch is dangerous and must be
•
repaired.
•
Store idle tools out of reach of children and other untrained persons. Tools are dangerous in the hands of untrained users.
•
Use only accessories that are recommended by the manufacturer for your model. Accessories that may be suitable for one
tool, may become hazardous when used on another tool.
SERVICE
Tool service must be performed only by qualified repair personnel. Service or maintenance performed by unqualified
•
personnel could result in a risk of injury.
When servicing a tool, use only identical replacement parts. Follow instructions in the Maintenance section of this manual.
•
Use of unauthorized parts or failure to follow Maintenance Instructions may create a risk of electric shock or injury.
To locate your nearest D
WALT service center call 1–800–4-D
e
the Internet.
Operating Tips
•
Use only new, high-quality, name brand batteries for best results.
•
Ensure batteries are in good working condition. If the low battery red indicator light is flashing, the batteries need replacement.
•
To extend battery life, turn laser off when not working with or marking the beam.
To ensure the accuracy of your work, check to make sure your laser is calibrated often. See Field Calibration Check.
•
•
Before attempting to use the laser, make sure it is positioned securely, on a smooth, flat surface.
•
Always mark the center of the beam created by the laser.
•
Extreme temperature changes may cause movement of internal parts that can affect accuracy. Check your accuracy often while
working. See Field Calibration Check.
•
If the laser has been dropped, check to make sure your laser is still calibrated. See Field Calibration Check.
1
as shown in Figure A.
WALT (1–800–433–9258) or go to http://www.D
e
3
–
+
WALT.com on
e
ENGLISH
1
+
Publicidad
