Publicidad
Idiomas disponibles
Idiomas disponibles
SPIN SPEED button
By pressing this button, it is possible to
reduce the maximum speed, and if you
wish, the spin cycle can be cancelled.
If the label does not indicate specific
information, it is possible to use the
maximum spin expected in the program.
To prevent damage to the fabrics, it is
not possible to increase the speed
over the maximum allowed for the
programme.
To reactivate the spin cycle press the
button until you reach the spin speed you
would like to set.
It is possible to modify the spin speed
without pausing the machine.
An over dosing of detergent can
cause
excessive
appliance detects the presence of
excessive foam, it may exclude the
spinning phase or extend the duration
of the program and increase water
consumption.
The machine is fitted with a special
electronic device, which prevents the
spin
cycle
should
unbalanced. This reduces the noise
and vibration in the machine and so
prolongs the life of your machine.
DELAY START button
This button allows you to pre-programme
the wash cycle to delay the start of the
cycle for up to 24 hours.
To delay the start use the following
procedure:
- Select the required programme.
foaming.
If
the
the
load
be
- Press the button once to activate the
delay start and then press it again (or
hold it) to set the desired delay. The
delay increases each time the button is
pressed up to 24 hours, at which point
pressing the button again will reset the
delay start to zero.
- Confirm by pressing the START/PAUSE
button. The delay countdown will begin
and when it has finished the programme
will start automatically.
It is possible to cancel the delay start by
turning the programme selector to OFF.
If there is a break in the power supply
whilst the machine is operating, when
the power is restored, the machine will
restart from the beginning of the phase it
was in when the power was lost.
ANTI-CREASE button
(Available on some programmes only)
This function allows you to minimize
creases as much as possible, eliminating
the intermediate spins or reducing the
intensity of the last one.
This option must be selected before
pressing the START/PAUSE button.
If the option is not compatible with the
selected programme then the option
indicator light first flashes and then
goes off.
OPTIONS button
This button allows you to choose between
three different options:
- PREWASH
This option allows you to make a prewash
and it is particularly useful for heavily
soiled loads (can be used only on some
programmes as shown in the table of
programmes).
We recommend you use only 20% of the
recommended quantities shown on the
detergent pack.
75
Publicidad
