Publicidad
Idiomas disponibles
Idiomas disponibles
12. Transport
Use the transport handle (1) to transport the device, and drive the compres-
sor with it.
When lifting the compressor, note its weight (see Technical data).
Ensure that the load is well secured when transporting the compressor in
a motor vehicle.
13. Disposal and recycling
Notes for packaging
The packaging materials are recyclable. Please
dispose of packaging in an environmentally
friendly manner.
Notes on the electrical and electronic equipment act [Elek-
troG]
Waste electrical and electronic equipment does not
belong in household waste, but must be collected
and disposed of separately!
• Used batteries or rechargeable batteries that are not installed perma-
nently in the old appliance must be removed non-destructively before
disposal. Their disposal is regulated by the battery law.
• Owners or users of electrical and electronic devices are legally obliged
to return them after use.
• The end user is responsible for deleting their personal data from the old
device being disposed of!
14. Troubleshooting
Fault
Possible cause
The compressor does
Mains voltage is not available.
not start.
Mains voltage is too low.
Outside temperature is too low.
Motor is overheated.
The compressor starts but
The safety valve leaks.
there is no pressure.
The seals are damaged.
The drain screw for condensate leaks.
The compressor starts,
The hose connections have a leak.
pressure is shown on the
pressure gauge, but the
A quick coupling has a leak.
tools do not start.
Insufficient pressure set on the pressure regulator.
8
GB/IE/NI/CY/MT
• The symbol of the crossed-out dustbin means that waste electrical and
electronic equipment must not be disposed of with household waste.
• Waste electrical and electronic equipment can be handed in free of
charge at the following places:
- Public disposal or collection points (e.g. municipal works yards)
- LIDL offers you return options directly in the branches and stores. Re-
turn and disposal are free of charge for you.
- Up to three waste electrical devices per type of device, with an edge
length of no more than 25 centimetres, can be returned free of charge
to the manufacturer without prior purchase of a new device from the
manufacturer or taken to another authorised collection point in your
vicinity.
- Further supplementary take-back conditions of the manufacturers and
distributors can be obtained from the respective customer service.
• If the manufacturer delivers a new electrical appliance to a private
household, the manufacturer can arrange for the free collection of the
old electrical appliance upon request from the end user. Please contact
the manufacturer's customer service for this.
• These statements only apply to devices installed and sold in the coun-
tries of the European Union and which are subject to the European Di-
rective 2012/19/EU. In countries outside the European Union, different
regulations may apply to the disposal of waste electrical and electronic
equipment.
Remedy
Check the cable, mains plug, fuse and socket.
Make sure that the extension cable is not too long. Use an extension cable
with large enough wires.
Never operate with an outside temperature of below +5 °C.
Allow the motor to cool down. If necessary, remedy the cause of the over-
heating.
Contact your local service centre. Only allow qualified personnel to carry
out repairs.
Check the seals and have any damaged seals replaced by a service centre.
Tighten the screw by hand. Check the seal on the screw and replace if
necessary.
Check the compressed air hose and tools and replace if necessary.
Contact your local service centre. Only allow qualified personnel to carry
out repairs.
Increase the set pressure with the pressure regulator.
Publicidad
