Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1
Installing the faucet assembly
CAUTION : Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
Shut off the water supply. Remove the old
faucet.
Clean the mounting surface.
Place the faucet (J) through the mounting holes
in the sink.
Ensure the slot openings of the rubber spacer (F)
and metal spacer (G) face toward to the rear of
the sink.
Secure the faucet (J) to the sink using the lock
nut (H) provided.
J
F
G
H
2
J
F
G
H
H
4
Installing the faucet handles
Remove the preassembled guide washers (E),
metal washers (D), and rubber washers (C) from
the hot and cold faucet handles (A and K).
Loosen the screws on the guide washers (E) until
the ends of the screws are flush with the face of
the guide washers (E).
Insert the hot faucet handle (A) to the left of the
spout and cold faucet handle (K) to the right of
the spout.
Attach the faucet handles (A and K) underneath the
sink using the rubber washers (C), metal washers (D),
and guide washers (E). Securely tighten the screws
on the guide washers (E).
A
A
C
D
E
E
K
K
E
Publicidad
