Publicidad
Idiomas disponibles
Idiomas disponibles
SBE 64 18-EC/SBE 127 18-EC
guide and can pinch your fingers.
■ Before starting to cut, turn tool "ON" and
allow the blade to come to full speed. Tool
can chatter or vibrate if blade speed is too
slow at beginning of cut.
■ Do not touch the blade or the workpiece
immediately after operation. Blade and
workpiece will be hot.
■ When removing the blade from the tool
avoid contact with skin and use proper
protective gloves when grasping the
blade or accessory. Accessories may be hot
after prolonged use.
■ Do not "jam" the blade or apply excessive
pressure to the tool when cutting.
Overstressing the blade increases the loading
and susceptibility to twisting or binding of
the blade in the cut and the possibility of
blade breakage.
Noise and vibration
The noise and vibration values have been
determined in accordance with EN 60745.
The A evaluated noise level of the power tool
is typically:
– Sound pressure level L
SBE 64 18-EC
SBE 127 18-EC
– Sound power level L
SBE 64 18-EC
SBE 127 18-EC
– Uncertainty:
Total vibration value when sawing steel tube:
– Emission value a
SBE 64 18-EC/ SBE 127 18-EC <2.5 m/s
– Uncertainty:
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The declared vibration total value(s) and
the declared noise emission level given in
this information sheet has been measured
in accordance with a measurement method
standardized in EN 60745 and may be used
to compare one tool with another.
It may be used for a preliminary assessment of
exposure. The specified vibration emission level
represents the main applications of the tool.
:
pA
82.3 dB(A);
81.9 dB(A);
:
WA
93.3 dB(A);
92.9 dB(A);
K = 3 dB.
:
h
K = 1.5 m/s
However, if the tool is used for different
applications, with different cutting accessories
or poorly maintained, the vibration emission
level may differ.
This may significantly increase the exposure
level over the total working period.
To make an accurate estimation of the vibration
exposure level, it is also necessary to take into
account the times when the tool is switched off
or running but not actually in use.
This may significantly decrease the exposure
level over the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration
such as: maintain the tool and the cutting
accessories, keep the hands warm, organization
of work patterns.
WARNING!
The vibration and noise emissions during
actual use of the power tool can differ from
the declared value in which the tool is used;
In order to protect the operator, user should
wear ear protectors in the actual conditions of
use.
CAUTION!
Wear ear defenders at a sound pressure
above 85 dB(A).
Technical data
Tool
2
Type
2
Rated voltage Vdc 18
No-load speed
Blade
Dimension
Max. Cutting
Depth
SBE 64
SBE 127
18-EC
18-EC
Compact
Deep Cut
Band Saw
Band Saw
18
m/
0-192
0-192
min
835x 13x
1140 x 13
mm
0.5
x 0.5
Round Stock
64
127
mm
Rectangular Stock
64x64
127x127
17
Publicidad
