IMOU RV-L11-A Manual De Instrucciones página 25

Troubleshooting
When an abnormality occurs while the device is running, the power indicator light will flash red quickly. There will
be voice prompts for some abnormalities. Refer to the table below for possible solutions.
The robot vacuum cleaner will automatically hibernate if there are no operations within 60 minutes of entering sleep mode.
i
Voice Prompts/
Fault Description
Check if the radar is stuck
Check if the bumpers are stuck
Clean the cliff sensor. Then,
start the unit after removing it
from the danger area.
Check if the main brush is stuck
Check if the side brush is stuck
Check if the main wheel is stuck
Put back the water tank before
restarting the device
The battery is insufficient. Start
recalling the device to the dock
for charging.
Fan is abnormal
Wipe the wall-following sensor
on the right side
Pressure on the top cover of the
laser radar
Battery is damaged or has not
been properly installed
Possible Reason
Laser radar is blocked or stuck
Collision sensor is stuck
Cliff sensor is triggered after starting
the device
Main brush is stuck
Side brush is stuck
Main wheel is stuck
Two-in-one water tank is
removed
Battery is insufficient while
cleaning
Fan is abnormal
Wall-following sensor is
abnormal
Top cover on the radar is stuck
Battery is abnormal while
charging
24
Solutions
Remove obstacles, or move the device to a flat and open area,
and restart it.
Clean and remove any foreign debris around the bumpers, or
move the device.
Remove and clean the cliff sensor. Then, move it to a flat and
open area before starting it.
Clean the main brush or move the device.
Clean the side brush or move the device.
Clean the main wheel or remove the device.
Install back the two-in-one water tank and filter while ensuring
that they are installed in the right place.
The battery is insufficient. Charge the device before use.
Ensure that the air ducts, filter, and other relevant parts of the
device are dry and free from water stains before attempting to
turn off and restart the device.
Wipe clean the wall-following sensor.
The laser radar is stuck or under pressure. Move the device to a
new position and restart it.
The battery temperature is too high or too low. Wait until the
battery temperature is normal before using it.
EN