Publicidad
Idiomas disponibles
Idiomas disponibles
NOTICE:
A small direction arrow and
a cutter pictogram is engraved in the
machine housing (Fig. 2d). When looping
the saw chain onto the guide bar, make
sure that, after mounting the guide
bar, the direction of the saw chain will
correspond to the rotation direction arrow
on the machine housing and the shape
of the cutters on the top of the guide
bar are consistent with that of the cutter
pictogram on the housing. If they face in
opposite directions, reassemble the saw
chain onto the guide bar with the arrows
facing the same direction.
7. Keep the bar and chain parallel
to the mounting surface with one
hand. Attach the side cover to the
housing so that the holes/pins and
fastening bolt/thread hole are aligned
with each other properly. Press the
side cover towards the housing, then tighten the cover nut (Fig. 2e).
NOTE:
If the chain is too loose or too tight, adjust the chain tension following
instructions in section "TENSIONING THE SAW CHAIN".
8. Rotate the chain by hand to check whether the chain is properly assembled without
binding. Otherwise, reassemble the chain and bar.
TENSIONING THE SAW CHAIN
(Fig. 3)
1. Remove the battery pack.
2. Use the multi-function wrench to
loosen the cover nut until the guide
bar can be moved freely.
3. Use the multi-function wrench to turn
the tensioning screw clockwise to
tension the chain or counterclockwise
to slacken it.
4. Manually rotate the chain to check for fault-free running.
18
56-VOLT LITHIUM-ION COMMERICAL POLE SAW — PSX2510/PSX2510-FC
2d
2e
Side Cover
3a
Rotation Direction Arrow
Drive Sprocket
Cover Nut
1
2
3
Publicidad
