UFESA CL Nuuk+ Manual De Instrucciones página 19

5. Press the "Mode button" (a) to select the wind mode (Normal wind/ Natural wind/Sleep
wind). They are indicated by the corresponding indicators on the display panel:
A. Normal wind: the fan operates at constant speed according to the set wind: strong,
medium and low wind.
B. Natural wind: The fan motor operates irregularly according to the pre-programmed
computer program, and can be divided into strong, medium and low natural wind accor-
ding to the setting of the wind speed, making the air volume softer and more comfortable.
C. Sleep wind: When the sleep wind mode is selected, the fan motor enters into the sleep
wind computer program control, and the fan air volume gradually decreases.
When it is set to strong sleep wind, the fan will run for half an hour according to strong
natural wind, then turn to middle natural wind, and then turn to low natural wind after
half an hour, until the preset time is over or turned off.
When the medium sleep wind is set, the fan will operate at the middle natural wind for
half an hour, and then turn to the Low natural wind until the preset time is over, or it is
turned off.
When the initial setting is weak sleep wind, the fan operates according to the low natural
wind until the preset time is over or turned off.
1. Press the "Cool button" (e), the cool mode indicator lights up and the water pump will
be working. Before you touch the button, please ensure that the water tank is filled with
water. In the cool mode, the appliance pumps water from the water tank to generate
mist to humidify the air and improve the cooling effect.
To exit the cool mode, press the "Cool button" (e) again. The cool mode indicator turns
off.
2. Press the "Swing button" (c). The oscillation function moves the deflectors left and
right to adjust the direction of the air flow. The corresponding indicator will light on the
display panel.
3. The appliance can be programmed to automatically turn off from 1 to 12 hours. To use
the timer, press the "Timer button" (f) to cycle through the numbers of hours (From 1 to
12h). The corresponding hours indicators light up. When your desired number of hours
appears, stop pressing the "Timer button" (f). The timer will start immediately.
4. Press the "Light button" (g). All the indicator lights, including the room temperature
digital display will shut off. Press any button, all the indicator lights will turn on.
5. If the appliance is turned off when the "cool" function is running, the machine will run
at high wind speed for 5 minutes and will shut down automatically after the wet curtain
is dried.
ADDING WATER
Before using the cool mode, you must add water to the water tank of the appliance.
You may also add ice boxes to the water tank to improve the cooling effect. Make sure
the appliance is not connected to an electrical socket.
There are 2 ways to Add water:
(1) Turn the lock button of the water tank to the left (see pic1), pull out the drawable
water tank, and then slowly pour some clean tap water into the water tank (pic 2). Note:
When adding water, observe the water level through the water level mark of the water
tank at back. Do not exceed the maximum water level of the water tank when adding
water.
19