Publicidad
Idiomas disponibles
Idiomas disponibles
7
OPERATION
7.1 DAILY INSPECTION
1.
Perform a visual inspection of the entire unit, look for signs of wear, loose hardware and missing or
damaged components. Check for fuel and oil leaks to ensure connections are tight and hoses and
tubes are in good condition.
2.
Check the fuel supply, crankcase oil level and air cleaner. All fluids must be at the full mark with the
engine cold.
3.
Make sure the cutting unit is adjusted to the required height of cut.
4.
Check all tyres for proper inflation (Super Certes Only).
5.
Test the operator presence and safety interlock system.
GB-24
SAFETY, OPERATORS & MAINTENANCE MANUAL
The daily inspection should be performed
only when the engine is off and all fluids
are cold. Lower implements to the
ground, engage parking brake, stop
engine and remove ignition key.
RANSOMES SMALL PEDESTRIAN RANGE
Publicidad
