Publicidad
Idiomas disponibles
Idiomas disponibles
10
ADJUSTMENTS
10.5 CYLINDER TO BOTTOM BLADE
ADJUSTMENT
To check that the cutting cylinder is set correctly to
the bottom blade: tilt the machine back, hold a thin
piece of paper between the edge of the blade and
spiral cutters and turn the cylinder manually.
The paper should be cut cleanly along the length of
the bottom blade, if not some adjustment is
necessary BUT DO NOT OVER TIGHTEN - the
cylinder must be able to turn freely.
Adjustment is made by loosening the locknut (A)
and turning the adjustment screws (B) clockwise to
move the cylinder towards the blade.
It is recommended that an eighth of a turn is made
alternately to each screw, checking frequently with
the paper until the correct setting is achieved.
WARNING
Turn petrol tap to the "OFF" position before
tilting the machine rearwards.
10.6 CYLINDER CLUTCH ADJUSTMENT
The adjustment of the cylinder clutch is made with
the clutch in the engaged position. slacken the two
nuts (B) either side of the plate, then turn them both
in the same direction until the correct adjustment
has been made. Retighten the nuts.
GB-36
RANSOMES SMALL PEDESTRIAN RANGE
SAFETY, OPERATORS & MAINTENANCE MANUAL
A
B
C
Publicidad
