Sony PWS-300TD2 Guia De Instalacion página 21

System Configuration Examples
Connect VTRs and external monitors to the SDI
connectors of the unit, and drive units to the USB 3.0
connectors on the rear panel. You can select a 2-input/2-
output, 3-input/1-output, or 4-input system configuration
by configuring SDI settings in the web application. Only
the 2-input/2-output configuration can be set for the SStP
codec. Any system configuration can be selected for the
XAVC-I, MPEG-HD, IMX, and Uncompressed SD
codecs.
Up to two drive units can be connected.
2 inputs/2 outputs
Connect two VTRs and two external monitors to the SDI
connectors. You can use this configuration to digitize
video from two VTRs in parallel.
The SStP (Single/DBL) codec uses the SDI connectors of
two SSTP CODEC CARDs. The XAVC-I, MPEG-HD,
IMX, and Uncompressed SD codecs use the SDI
connectors on the XAVC 4K/HD CODEC CARD.
VTR
REF
Operator Operator
HD/SD SDI
RS422
HD/SD SDI
RS422
REF IN
Sync signal
Notes
• If multiple VTRs are connected, make sure that all VTRs are synchronized
(±1H).
• Set the EE/PB setting of the VTR to PB.
Manager
Gigabit Ethernet
HD/SD SDI
HD/SD SDI
USB 3.0
Main unit
USB 3.0
External monitor
Drive unit
21
Overview