Sony PWS-300TD2 Guia De Instalacion página 27

Connections
VTR1
VTR2
VTR3
VTR4
This configuration uses the REMOTE 3/4 and REMOTE 5/6 connectors.
RAID Configuration Selection
After setting the system configuration, set the RAID configuration so that it has the same number SDI inputs and logical
drives as the selected system configuration.
• For 2 inputs/2 outputs: (5D + 1P) × 2
• For 3 inputs/1 output: (3D + 1P) × 3
• For 4 inputs: (2D + 1P) × 4
Notes
• If the RAID configuration is changed, all full-resolution files, proxy files, report files, and work orders written in internal storage are deleted.
Before changing the RAID configuration, always transfer or download all data to prevent data loss.
• If the SYSTEM indicator is lit red to indicate an HDD requires replacement, or while rebuilding is in progress due to HDD replacement, the storage
performance is reduced and recording/playback may not operate normally. To check whether rebuilding is in progress, check the indicators of each HDD slot
with the front panel of the unit removed. Rebuilding is in progress if an indicator is flashing amber.
About RAID configuration
The PWS-300TD2 (PWS-300 + PWA-TD1) supports the following RAID configurations when a total of 12 HDDs are
installed.
• 2D + 1P: Contains a total of four logical drives, where each logical drive contains two data HDDs and one parity HDD.
• 3D + 1P: Contains a total of three logical drives, where each logical drive contains three data HDDs and one parity HDD.
• 5D + 1P: Contains a total of two logical drives, where each logical drive contains five data HDDs and one parity HDD.
RS422
HD/SD SDI
RS422
HD/SD SDI
HD/SD SDI
RS422
HD/SD SDI
RS422
27
Overview