Mx Onda MX-PIP2200 Manual De Instrucciones página 24

If there is any anomaly or problem in the operation of the induction hob, screen 3
will show the error detected. Error messages appear on the screen with the letter
"E" followed by a number, consult the following table to identify the error and the
solution.
Message
Internal circuit error.
E0
No container or container is not
E1
suitable for induction hobs.
IGBT sensor overheating
E2
Overvoltage protection.
E3
Low voltage protection.
E4
Top plate sensor open/short circuit.
E5
IGBT sensor open/short circuit
E6
Top Plate Overheating/Invalid Top
E7
Plate Sensor.
MAINTENANCE AND CLEANING
Before cleaning, disconnect the unit from the mains. And make sure the plate is
completely cold. Do not use alcohol or abrasive products and do not allow the
appliance to come into contact with volatile agents such as gasoline, solvents,
insecticides, etc.
Cleaning the hob
•
After each use you must clean the plate, in this way you will prevent any
adhered remains from burning.
•
Do not clean the plate until it is cool enough.
•
Only use specific products for cleaning induction hobs, otherwise you could
damage the cooking surface.
•
Descripción
Contact our nearest MX ONDA Customer
Service.
Place a container on the cooking zone or
replace the invalid container.
Failure in the ventilation system, check that
the fan is not obstructed and is working
correctly. Unplug the induction hob and let it
cool.
If the voltage at the output mains is higher
than specified, consult a qualified electrician.
If the voltage on the output mains is less than
specified, consult a qualified electrician.
Contact our nearest MX ONDA Customer
Service.
Contact our nearest MX ONDA Customer
Service.
Unplug the induction hob and let it cool.
24
Solution