Publicidad
Idiomas disponibles
Idiomas disponibles
Model #
Rating: Btu/Hr / kW
Fuel Consumption: Gal/Hr / L/Hr
Fuel Tank Capacity: Gallons / Liters
Pump Pressure: psi / BAR
Volts: AC/Hz
Amps
Phase
Upper Shell
Hot Air Outlet
Lower Shell
Lamp
Thermostat Knob
(80T KFA Only)
Fuel Tank
Power/Reset Switch
ASSEMBLY INSTRUCTIONS (140T-KFA / 190T-KFA / 215T-KFA)
1.
Insert axle through holes in wheel support.
2. Slide spacer onto axle.
3. Slide wheel onto axle and hold in place with the
axle nuts (see Figure 1).
Wheel Support Frame
Tire
Axle Nut
4. Place heater on wheel support and line up holes
on the fuel tank lip.
5. Attach front handle with (2) long screws (50 mm)
and (2) nuts through the second hole from the
front on both sides of the tank lip and wheel sup-
port frame and tighten firmly.
6. Insert (2) short screws (30 mm) through the first
hole from the front in the tank lip and tighten
firmly. Make certain all (4) screws are secure.
© 2021 Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
SPECIFICATIONS
45-KFA
45,000 / 13.19
0.35 / 1.32
5 / 19
3.0 / 0.21
120VAC / 60Hz
1.4
Single
Specifications subject to change without notice.
Extension Cord Wrap
Handle
Fan Guard
Pressure Gauge
Fuel Gauge
Fuel Cap
Power Cord
Axle
Spacer
Figure 1
WHILE CONNECTED TO A POWER SOURCE
80T-KFA
140T-KFA
80,000 / 23.4
140,000 / 41
0.63 / 2.38
1.1 / 4.16
5 / 19
10 / 38
4.2 / 0.29
6.6 / 0.46
120VAC / 60Hz
120VAC / 60Hz
1.5
Single
Single
FEATURES
Front
Handle
Hot Air
Outlet
Lower Shell
Fuel Gauge
Fuel Cap
7. Attach rear handle with (2) long screws
(50 mm) and (2) nuts through the second hole
from the rear of the heater on either side (see
Figure 2).
8. Tilt the heater up gently so it is resting on the
front handle.
NOTE: DO NOT do this if there is fuel in the tank.
9. Remove the wheels to secure the second set of
screws through the rear handle.
10. Secure the rear handle
with (2) short screws
(30 mm) and (2) nuts
and tighten firmly.
11. Replace wheels and
tighten with the wheel
nuts.
12. Tilt heater back down
onto wheels and check
all screws and nuts to
ensure they are secure.
5
Kerosene Forced Air Heater User's Manual
190T-KFA
190,000 / 55.68 215,000 / 63.01
1.42 / 5.38
13 / 49
8.5 / 0.59
120VAC / 60Hz
2.4
2.7
Single
Upper Shell
Digital Temperature
Display
Lamp
Thermostat
Knob
Figure 2
215T-KFA
1.63 / 6.17
13 / 49
9.0 / 0.62
120VAC / 60Hz
2.8
Single
Rear Handle
Fan Guard
Pressure
Gauge
Fuel Tank
Drain Bolt
Power
Cord
Publicidad
