Accessories; Stem Deflector; Extension; Side Ejector - avdel Genesis G4 HD Manual De Instrucciones

A c c e s s o r i e s
S t e m D e f l e c t o r
The stem deflector is a very simple alternative to the standard
stem collector and allows access in restricted areas. It is easy
to fit to the tool as follows:
•
Unscrew retaining nut 26 by inserting a 3 millimetre
diameter rod into one of the holes.
•
Remove retaining nut 26 and the stem collector assembly,
items 18, 20, 21, 22, 23, 24, and 25.
•
Screw the adaptor nut onto end cap 27.
•
Push the boss end of the stem deflector into the internal
groove of the adaptor nut.
•
Rotate the stem deflector until the aperture faces away
from the operator and other person(s) in the vicinity.
E x t e n s i o n
Fitted between the tool and the nose assembly, the extension
gives an extra reach of 76 millimetres, ideal for use in deep
narrow applications.
•
To fit the extension, remove any nose assembly
components.
•
Screw the inner extension onto jaw spreader housing 1.
•
Screw the outer casing onto head assembly 4.
•
Screw the nose assembly onto the extension.
S i d e E j e c t o r
Fitted between the tool and the nose assembly, the side
ejector forces fastener stems to eject at the front of the tool
and gives an extra reach of 90mm. It is not an option when
placing Maxlok ® fasteners.
•
To fit the side ejector, remove any nose assembly
components.
•
Remove the socket cap screw from the side ejector.
•
Screw the inner extension onto jaw spreader housing 1.
•
Screw the outer casing onto head assembly 4.
•
Replace the socket cap screw securing with Loctite
Screwlock 222, part number 07900-00371.
•
Screw the nose assembly onto the side ejector.
For greater ease of use, it is recommended that the stem
collector or stem deflector is replaced with safety cap part
number 71210-20201. 'O' ring 19 must remain.
Item numbers in bold refer to the general assembly drawing and parts list on pages 18-19.
12
STEM DEFLECTOR
ADAPTOR NUT
71210-20101
KIT PART NUMBER: 71210-20100
OUTER CASING
INNER

EXTENSION

STANDARD EXTENSION PART NUMBER: 71210-20300
3 / " & 1 / " MAXLOK ® EXTENSION: 71230-20300
16 4
STEM DIAMETER
OUTER CASING
INNER
EXTENSION
Part number: 07498-00900
for fasteners with a stem larger than 3.1 mm (
07340-00342
8-32 x / " SOCKET
1
4
CAP HEAD SCREW
/ ") Ø
1
8