Publicidad
Idiomas disponibles
Idiomas disponibles
If necessary, adjust motion sensor with DIP switch 9 . For detail, please refer section "Setting the
motion sensor" in full manual.
Turn the glass cover 1 clockwise against the base 3 (See Fig. J).
Note: Make sure that the seal of the glass cover 2 and sealing ring 5 is positioned correctly
and in place.
Replace the fuse or turn on the circuit breaker in the fuse box (I position). The product is now ready
for use.
˜ Replacing the bulb
Note: To avoid burns, only change the bulb when the LED ceiling light is disconnected from the mains
and the LED bulb 4 is cool.
Before changing the bulb, make sure that there is no voltage present. To do this, remove the fuse or
turn off the circuit breaker in the fuse box (0 position).
Wait approx. 3 minutes until the LED bulb 4 is cool.
Turn the glass cover 1 anti-clockwise against the base 3 .
Insert the new LED bulb 4 .
Turn the glass cover 1 clockwise against the base 3 until tight.
Note: Make sure that the seal of the glass cover 2 and sealing ring 5 is positioned correctly
and in place.
Replace the fuse or turn on the circuit breaker in the fuse box (I position). Check that the LED ceiling
light is functioning correctly.
˜ Setting the motion sensor
By changing the combination on the motion sensor with DIP switch 9 you can set the sensor function
for your specific application.
1. Adjusting the detection range
Using motion sensor with DIP switch 9 you can adjust the detection range of the motion sensor to
one of five settings. It is important to note that the maximum detection range may decrease as the
installation height increases.
Case
I
II
III
IV
V
VI
2. Adjusting the light-on time
Using motion sensor with DIP switch 9 you can adjust the light-on time of the LED ceiling light to
one of six settings
Note: The light-on time is the time for which LED ceiling light is illuminated at 100% intensity after it
detects motion.
DIP switch
1
2
3
ON
ON
ON
OFF
ON
ON
ON
OFF
ON
OFF
OFF
ON
OFF
OFF
OFF
-
-
-
Detection range
100%
75%
50%
25%
10%
-
Detection distance
approx. 12 m
approx. 9 m
approx. 6 m
approx. 3 m
approx. 1.2 m
-
GB/IE
19
Publicidad
