Publicidad
Idiomas disponibles
Idiomas disponibles
Case
I
II
III
IV
V
VI
3. Adjusting the ambient brightness
Using motion sensor with DIP switch 9 you can select one of six settings for the sensor so that the
LED ceiling light only lights up when the ambient brightness falls below a specified threshold. (50
lux, 25 lux, 10 lux, 2 lux)
If you select "Disable", it means the daylight sensor does not work. The sensor will turn on light
once motion is detected regardless of ambient light level.
Case
I
II
III
IV
V
VI
˜ Maintenance and cleaning
Allow the product to cool down completely.
Do not use solvents, benzene or similar substances. They could damage the product.
WARNING! DANGER TO LIFE BY ELECTRIC SHOCK!
Before carrying out any tasks on the product, switch off the electrical circuit at the circuit breaker box
or remove the fuse from the fuse box.
WARNING! RISK OF ELECTRIC SHOCK!
For electrical safety, never clean the product with water or other liquids, or immerse it in water.
Only use a dry, lint-free cloth for cleaning.
After finished the maintenance and cleaning, screw the fuse on and / or switch the circuit breaker
on again.
˜ Disposal
The packaging is made of environmentally friendly materials, which you be disposed through your local
recycling facilities.
Observe the marking of the packaging materials for waste separation, which are marked with
abbreviations (a) and numbers (b) with following meaning: 1–7: plastics/20–22: paper and
fibreboard/80–98:composite materials.
20 GB/IE
DIP switch
4
5
6
ON
ON
ON
OFF
ON
ON
ON
OFF
ON
OFF
OFF
ON
ON
ON
OFF
OFF
OFF
OFF
DIP switch
Ambient brightness
7
8
9
ON
ON
ON
ON
ON
OFF
OFF
ON
OFF
ON
OFF
OFF
OFF
OFF
OFF
-
-
-
Light-on time
5 sec
30 sec
90 sec
3 min
20 min
30 min
2 lux
10 lux
25 lux
50 lux
Disable
-
Publicidad
