Network Provider At The External Analogue Port; Internet And Voip Terminals As Well As Pc And Printer At The Ethernet Port - Auerswald COMpact 5200 Manual De Instrucciones

Installation
Requirements:
• Enabled operating mode "S
• Terminators enabled at both ends of the connection – in the NTBA and in the PBX on the
external S port in question
0
operating mode "S external"
0
If the NTBA only has a slight distance to the
PBX, make a direct connection via the RJ45
socket (cable in the scope of delivery).
If the NTBA has a greater distance to the
PBX, then a cable must be laid fixed on the
terminal clamps of the external S

Network Provider at the External Analogue Port

Warning: Voltages that run through the connection socket of the network provider can
cause life-threatening electric shocks.
• Do not connect the PBX until the casing on the connection socket of the network provider
is closed again.
Connection possibilities:
• Public analogue telephone network across Europe
• Analogue GSM gateway
If the analogue connection has a greater distance to the
PBX, a cable with a wall socket at the terminal clamps of
the external analogue port must be laid fixed. Connect
the devices with the RJ-11/RJ-11 connection cable
included in the scope of delivery. Within Germany, you
additionally require the RJ-11/TAE-F adapter.

Internet and VoIP Terminals as well as PC and printer at the Ethernet Port

Connection possibilities:
• PC
• Printer
54
external" on the S
0 0
port.
0
COMpact 5200/5200R/5500R - Instructions V01 03/2017
port in question
terminators enabled
NTBA
external analogue port
RJ-11 wall socket
external S port
0