HIKOKI WHP 18DA Instrucciones De Manejo página 10

English
22 Driver bit (sold separately)
23 Bit piece
24 Remaining battery indicator switch
25 Remaining battery indicator lamp
26 Display panel
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
WHP18DA: Cordless Oil Pulse Driver
To reduce the risk of injury, user must read
instruction manual.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive
2012/19/EU on waste electrical and electronic
equipment and its implementation in
accordance with national law, electric tools that
have reached the end of their life must be
collected separately and returned to an
environmentally compatible recycling facility.
Direct current
V
Rated voltage
n
0
No-load speed
Pm Power mode
Nm Normal mode
Sm Soft mode
SEm Self drilling screw mode
Bpm Impact rate
S
Small screw
Ordinary bolt
SE
Self drilling screw
MT
Tightening torque (Maximum)
Hex. drive size
Weight * 1
kg
(According to EPTA-Procedure 01/2014)
Switching ON
0
Switching OFF
Disconnect the battery
Clockwise rotation
Counterclockwise rotation
Soft mode (Red light)
"Delicate work"
Tightening small diameter screws (M6 or
similar), etc.
Normal mode (Red light)
"Normal work"
Tightening short screws, Affixing plasterboard,
etc.
Power mode (Red light)
"Normal work"
Tightening long screws, coach screws, bolts,
etc.
Self drilling screw mode (Green light)
Self drilling screw tightening
Press and hold, and keep holding
LED light brightness: Low
LED light brightness: Medium
LED light brightness: High
Warning
*1 Depending on attached battery. The heaviest weight is
measured with BSL36B18X (sold separately).
Battery
Lights ;
The battery remaining power is over 75%.
Lights ;
The battery remaining power is 50%–75%.
Lights ;
The battery remaining power is 25%–50%.
Lights ;
The battery remaining power is less than 25%.
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
10