Pairing Process - Mitsubishi Electric ecodan PAR-WT50R-E Manual De Instalación Y Configuración

Place the wireless receiver on the fixed bracket.
Hook the holes on the back of the wireless re-
ceiver onto the projections on the bracket, and
fix the wireless receiver.
<Notice>
● Do not place the wireless receiver inside the hydrobox.
►Both the wireless receiver and its wire may break due to heat inside the indoor unit.
● Do not pull the cable excessively.
►Breakdown, ignition, or fire may result.
● Do not have the wireless receiver suspended.
►Breakdown, ignition, or fire may result.
Hold the front panel with the screws.

5. Pairing process

● If the wireless remote controller is not paired, the indoor unit cannot be operated
using the remote controller.
● Before using the wireless remote controllers, always ensure to go through a pairing
process.
● Pairing is NOT possible unless the ecodan system is off. When the ecodan system
is ON, be sure to turn it off before starting the pairing process.
● The wireless receiver is also needed for pairing, so please make sure to operate the
wireless remote controller near the wireless receiver.
Hold down button on the wireless receiver
for 3 seconds or more until orange
blinks.
The pairing mode is cancelled by pressing
button.
Hold down ,
ously for at least 3 seconds until the mode
number blinks.
and buttons simultane-
LED
Blinking (orange)
Mode No.
10