Mitsubishi Electric ecodan PAR-WT50R-E Manual De Instalación Y Configuración página 6

Remove the screw and pull the control and electrical box so that the control and electrical
box is swung toward you from left.
Screw
(1 position)
Run the receiver's cable into the cylinder unit
through the inlet as shown on the figure.
Do not run the receiver's cable through an
inlet that a power cable goes through and
do not bundle the cable together with a
power cable.
Route the cable out the back of the control and electrical box, and run the cable into the box
through the shown inlet in the underside of the box.
Control board
5
Control and electrical box
Control and
electrical box
Screws
(2 positions)
Receiver's cable
Control and electrical box
Control and
electrical box