Orved MULTIPLE 315VM P4-P8 Manual De Uso Y Mantenimiento página 58

GB
USING THE APPLIANCE
13) CONFIRMING THE PROGRAMMING: There are three ways to confirm the program set:
- press ;
- press until the program number reappears and the display stops flashing;
- wait for about seven seconds without pressing any key.
It is now possible to proceed with other program settings, or proceed with packaging.
14) STARTING THE WORK CYCLE: Lower the lid with both hands pressing slightly on the
corners. The appliance will start the work cycle according to the programmed parameters.
15) WORK CYCLE END: The appliance ends the cycle automatically after the sealing bar cooling, with air re-entering the chamber resulting in opening
of the lid. Remove the packed product and check the bag seal: it must be uniform, clearly marked without melted points.
If necessary, adjust the preset values and proceed with the second cycle.
The work cycle can be interrupted at any moment by pressing
also be interrupted by means of the main switch; the cycle is interrupted but air does not re-enter the suction cup: the lid therefore remains closed.
When the machine is switched on again, the cycle is reset, air returns to the chamber and the lid opens.
PROCEEDING TO THE SUCCESSIVE PHASE IN ADVANCE MULTIPLE 315-P4/P8 - VM12 - VM16
It is possible to proceed to the successive function before reaching the maximum value, by pressing
CREATING VACUUM IN EXTERNAL CONTAINERS
1) Screw hose connector (A) supplied with the machine on the union provided on the front of the machine and insert hose (B) provided with suction
cup (C).
2) Prepare the lid provided with valve by unscrewing ring nut (D) slightly so that the sealing plug inside it can move.
3) Position the suction cup on the lid valve after placing the lid on the container (jar, vessel, vacuum box, etc.),
inside which vacuum is to be created.
4) Close the jars valve (E)fitted on the side of the appliance.
5) Activate the function by pressing the yellow key
maximum vacuum.
6) Open cock lever (E). Vacuum is formed in the container. When the operation ends, press
7) Tighten ring nut (D) on the wall promptly to prevent air from entering the container.
E
OPEN
•
G B
CLOSED
GB
Operation and maintenance manual / Ed. 10 - 2005
INTERRUPTING THE WORK CYCLE MULTIPLE 315-P4/P8 - VM12 - VM16
PROGRAMMING THE JARS FUNCTION MULTIPLE 315-P4/P8 - VM12 - VM16
•
A
•
B
D
•
; interruption is immediate with air re-entering the chamber. The work cycle can
and lower the machine lid (F). Wait for the vacuum gauge to indicate
C
•
•
D
58
VACUUM CHAMBER
PACKAGING MACHINES
.
.
F
•
B
•
REV. 00 - Cod.: 1500154