Waeco CoolMatic CR-50 Instrucciones De Uso página 41

COOLMATIC CR Series
➤ Choose the condensation outlet most suitable for the place of installation
and remove its cap.
➤ Insert a sharp object (e.g. a screwdriver) approx. 25 to 30 mm into the
outlet to pierce open the inside of the appliance.
If you put the refrigerator in a recess, you can fix it inside with suitable
screws:
➤ Remove the blanking plugs (fig. 7 2, page 6).
➤ Push the refrigerator into the recess.
➤ Use suitable screws (fig. 7 1, page 6) to fix the refrigerator in place.
➤ Press the blanking plugs (fig. 7 2, page 6) into the openings.
7.2 Undo the lock
The refrigerator has a locking mechanism (fig. 9 1, page 6) which is also
used, to protect it during transport. The following settings are possible:
Caution
a
Only adjust the locking mechanism when the door is open. If you
use it with the door closed, you will damage the device.
Lock (turn wheel clockwise to the end stop): The door is locked and
secured.
To open the door, lift the handle up and open it.
Vent (turn wheel anti-clockwise to the end stop): The door is slightly open,
but fixed in position.
Use this position, if you are not going to use the appliance for a long time.
7.3 Changing the door hinge
You can also change the hinge of the door, so that it opens to the left rather
than the right.
➤ Proceed as shown in fig. b, page 8 to fig. d, page 8, to change the
hinges.
Installing and connecting the refrigerator
41