English
or a mixture of liquids and soluble products, always
make the mixture before filling the tank. Do not use
the tank to make the mixes inside.
Do not use the fumigator to spray liquids or liquid
mixtures that are above 45ºC or less than 5ºC.
6.7. START UP AND STOPPING THE MACHINE
WARNING: The pump of this machine must not work
in a vacuum (without liquid). Never start this machine
without liquid to be sprayed in the tank.
6.7.1. SWITCHED ON
This machine has 2 ignition options:
100% pump: If you want to work with the pump at
maximum intensity, set the start switch to "I"
OFF
ON
Pump regulated between 0% and 100%: If you prefer
to regulate the intensity of the pump, turn on the
machine directly by turning the potentiometer.
6.7.2. STOP
Set the On / Off switch to the "O" position and the
potentiometer to the minimum.
6.8. LOW BATTERY INDICATOR
When your sprayer's battery is low, the power output
of the liquid will be less and you will need to charge
the battery.
6.9. VERIFICATION POINTS AFTER START-UP
It is important to pay attention to possible loose parts
and temperature of the machine. If you detect any
anomaly in the machine, stop immediately and check
it carefully. In case of any anomaly or problem take
the machine to the technical service to repair it. In no
case continue using the machine if the operation does
not seem appropriate.
Do not use the machine if it is damaged or
improperly regulated.
7. USING THE MACHINE
Use this machine only for the designated
purposes. Using this machine for any other use is
dangerous and can cause bodily harm and/or damage
to the machine.
7.1. PREPARING THE LIQUID TO BE SPRAYED
Prepare the product mix to be sprayed in a tank
in which you can insert the suction hose with the
filter and the return hose. Always follow the product
manufacturer's instructions and safety standards.
30/100